Privacy statement: Your privacy is very important to Us. Our company promises not to disclose your personal information to any external company with out your explicit permission.
English

What elongation measures Elongation describes how far the material stretches before breaking, as a percentage of its original length. A grade at 340% reaches roughly three times its length, a grade at 570% reaches considerably further. In production this is the mechanism a pad uses to reach surfaces that are not flat.
Where the deformation goes When a pad presses onto a curved part, the high point touches first and the surrounding material must stretch to follow the surface downward. A low elongation grade runs out of stretch before reaching the recess, so the graphic prints at the high point and disappears at the edge. A high elongation grade keeps stretching, contacts a larger area, and carries ink into the recess. That is the direct link between elongation and a complete print in one press.
The trade off Deformation is not free. A pad that stretches further also recovers more slowly, and slow recovery affects registration on multi colour work. High elongation suits single colour large area jobs and coated surfaces where coverage matters more than absolute edge sharpness. Low elongation with high tear strength stays with fine characters and tight registration. Trading one for the other without knowing which the part needs is how expensive mistakes start.
Pressure must be reset A soft high elongation pad deforms more at the same machine setting, so pressure suited to a 30 Shore A pad will over compress a 14 Shore A pad. Start low, confirm the contact footprint covers the graphic area, and increase only if edges stay clean. Excess pressure on a soft pad pushes ink outward and creates the blur that gets blamed on ink.
Geometry still beats numbers A round pad on a strongly curved part under performs regardless of elongation. Confirming the footprint on a trial pad, then shaping the head to follow the part, removes more defects than any datasheet comparison.
Practical conclusion Check the smallest feature, check registration tolerance, check curvature, then choose elongation. A grade with 570% elongation, tear strength 25±2 kN/m and a 100:2 condensation system covers coated and irregular parts without an oven or a second press, and stays stable through a full shift.
November 19, 2026
November 19, 2026
August 31, 2026
August 25, 2026
November 16, 2026
November 13, 2026
Email to this supplier
November 19, 2026
November 19, 2026
August 31, 2026
August 25, 2026
November 16, 2026
November 13, 2026
Privacy statement: Your privacy is very important to Us. Our company promises not to disclose your personal information to any external company with out your explicit permission.
Fill in more information so that we can get in touch with you faster
Privacy statement: Your privacy is very important to Us. Our company promises not to disclose your personal information to any external company with out your explicit permission.