Ms. zhou

What can I do for you?

Ms. zhou

What can I do for you?

Home> Company News> Why Low Viscosity Improves Pad Quality HONG YE SILICONE

Why Low Viscosity Improves Pad Quality HONG YE SILICONE

2026,11,20
Viscosity is usually read as a handling convenience. In pad moulding it decides the internal quality of the pad before anyone presses it.

What viscosity controls A lower viscosity compound flows further under its own weight before curing begins. That means it fills narrow sections of a mould, climbs into corners and lets bubbles rise out instead of being trapped against the surface. A higher viscosity compound needs pressure or vibration to do the same work, and any area it fails to reach becomes a defect.

Bubbles and surface quality Trapped air is the single most common cause of a pad that looks acceptable but prints badly. A pin hole at the surface does not carry ink, so the print shows a missing dot. Internal voids let the pad compress unevenly, which shows up as a soft spot in the middle of a graphic. Low viscosity plus short vacuum time removes most of this before cure.

Wall evenness and wall thickness Thick sections cure slower than thin ones, and uneven thickness changes how the pad deforms. A compound that flows well before gelation produces a more even wall, so the pad presses with consistent pressure across its face instead of favouring one side.

Scrap and changeover time Every extra minute of vacuuming or every re pour after a failed mould costs capacity. A grade that deairs quickly shortens the cycle, and a grade that fills reliably reduces the re work rate. Over a month these minutes add up to a meaningful difference in output, which is why viscosity belongs in the purchasing discussion and not only in the workshop.

Where low viscosity does not help Very low viscosity in a large open mould can flow away from thin ribs, and in that case a thixotropic adjustment or a slightly higher viscosity is the better answer. The right question is whether the mould geometry is filled evenly, not whether the number is small.

Conclusion Viscosity is a production variable, not a datasheet ornament. Choosing the grade whose flow matches the mould geometry reduces voids, evens wall thickness and cuts scrap, which is worth more than a small difference in price per kilogram.

Contact Us

Author:

Ms. zhou

E-mail:

alice@szrl.net

Phone/WhatsApp:

+86 18938861889

Popular Products
You may also like
Related Categories

Email to this supplier

Subject:
Email:
Message:

Your message must be between 20-8000 characters

  • Send Inquiry

Copyright © 2026 Shenzhen Hong Ye Jie Technology Co., Ltd All rights reserved. Privacy Policy

We will contact you immediately

Fill in more information so that we can get in touch with you faster

Privacy statement: Your privacy is very important to Us. Our company promises not to disclose your personal information to any external company with out your explicit permission.

Send